arthroscopic sabre  (Arthrex Inc)

Journal: JSES Reviews, Reports, and Techniques

Article Title: Clinical and structural midterm follow-up after surgical treatment of a traumatic delaminating chondral lesion of the humeral head using the minced cartilage technique: a case report

doi: 10.1016/j.xrrt.2026.100729

Figure Lengend Snippet: Arthroscopic images of the glenoid ( G ) and cartilage defect. Partly detached cartilage fragment ( A ) on the humeral head ( HH ), measuring of the cleaned chondral defect zone ( B and C ); glenoid ( G ).

Article Snippet: The defect zone was prepared for the autologous MCI by débridement while securing and simultaneously mincing the cartilage flake into chips using the arthroscopic Sabre 3 mm shaver and the GraftNet autologous tissue collector (both Arthrex Inc., Naples, FL, US).

Techniques:

Journal: JSES Reviews, Reports, and Techniques

Article Title: Clinical and structural midterm follow-up after surgical treatment of a traumatic delaminating chondral lesion of the humeral head using the minced cartilage technique: a case report

doi: 10.1016/j.xrrt.2026.100729

Figure Lengend Snippet: ( A-D ) Intraoperative images displaying the glenoid ( G ) and the humeral head ( HH ) with covered defect zone during re-arthroscopy for stiffness 6 months after arthroscopic minced cartilage implantation.

Article Snippet: The defect zone was prepared for the autologous MCI by débridement while securing and simultaneously mincing the cartilage flake into chips using the arthroscopic Sabre 3 mm shaver and the GraftNet autologous tissue collector (both Arthrex Inc., Naples, FL, US).

Techniques:

Journal: Orthopaedic Journal of Sports Medicine

Article Title: 2.0-mm Diameter Arthroscopy versus MRI in Predicting Appropriate Surgical Management of Intra-articular Shoulder Pathology: A Blinded, Prospective Study

doi: 10.1177/23259671261434938

Figure Lengend Snippet: NanoScope (Arthrex) is a single-use, chip-on-tip 2.0 mm–diameter scope with integrated digital imaging that delivers a 400 × 400–pixel high-resolution visualization of intra-articular structures. The arthroscope connects to a portable touchscreen monitor that serves as an interface for image capture, video recording, and system control.

Article Snippet: The SNA system used in this study was approved by the US Food and Drug Administration for diagnostic evaluation of intra-articular pathology and is an alternative to a rod-lensed arthroscope (Nanoscope; Arthrex Inc.).

Techniques: Imaging, Control

Journal: Foot & Ankle Orthopaedics

Article Title: All-Inside Endoscopic Zone 1 Flexor Hallucis Longus Transfer: A Cadaveric Feasibility Study

doi: 10.1177/24730114261442547

Figure Lengend Snippet: (A) Arthroscopic image of the FHL tendon with sliding suture knot prior to tenotomy. (B) Measurement of the FHL tendon pulled out of the anteromedial portal while in ~25° of plantarflexion. (C) Measurement of the FHL tendon prepared with FiberLoop while maintaining ~25° of plantarflexion. (D) Measurement of the FHL tendon diameter using a tendon sizer template. Note that anatomical measurements were taken after FHL tendon transfer was completed. Specimens were openly dissected to attain the most accurate anatomical measurements as indicated by the open images presented. FHL, flexor hallucis longus.

Article Snippet: While in the neutral position, using an arthroscopic suture passer (Arthrex CPR Viper), a sliding suture knot was placed in the FHL tendon adjacent to the posteromedial aspect of the subtalar joint to establish a baseline position of measurement, and create a means of tension ( ).

Techniques:

Journal: Foot & Ankle Orthopaedics

Article Title: All-Inside Endoscopic Zone 1 Flexor Hallucis Longus Transfer: A Cadaveric Feasibility Study

doi: 10.1177/24730114261442547

Figure Lengend Snippet: (A) Arthroscopic image of the tunnel demonstrating absence of tunnel blowout or violation of tunnel geometry. (B) A located and dissected neurovascular bundle following all-inside endoscopic FHL zone 1 tenotomy and transfer. (C) Arthroscopic image providing visualization while the tenodesis screw was placed into the drill tunnel in the calcaneus. (D) Arthroscopic image of the screw placed in the drill tunnel. It can be noted that some of the FiberLoop is visible above the biotenodesis screw.

Article Snippet: While in the neutral position, using an arthroscopic suture passer (Arthrex CPR Viper), a sliding suture knot was placed in the FHL tendon adjacent to the posteromedial aspect of the subtalar joint to establish a baseline position of measurement, and create a means of tension ( ).

Techniques: